Do Wood Floors Have To Be Refinished After Stripping

Use a stiff paint brush to spread the stripper over a surface of the wood in a thick even layer.

Do wood floors have to be refinished after stripping.

Staining floors especially for first time do it yourselfers is a tricky business. The contractor will sand the old finish off the floors repair any damaged areas and ensure all wood dust is cleared from the floors. 24 hours after floors have been sanded and finished they can be swept with a soft bristle broom only. Stain makes sander scratch shockingly visible.

Hit the area with a putty knife to scrape off the stripper along with the finish. Do not put too much denatured alcohol in the pan as it does tend to quickly evaporate. We re getting ready to finish our wood floors some new and some refinish. Apply enough stripper to keep the surface wet and never work in direct sunlight as you can dry the wood.

If you have a piece of wooden furniture you really like or a tired thrift store find with loads of potential give it new life with a fresh coat of stain. No vacuums until floors have fully cured. The equipment used in refinishing floors is noisy. And when it does go wrong the only solution is to re sand the floor and start all over from the beginning.

Leaving spots will yield an uneven surface when you finally start finishing it. Chemical stripping products come in a liquid spray or gel form. Asked this on the flooring forum but not much traffic there these days. When they polyurethane wears off the wood absorbs the water.

Although it gets most of the varnish off the furniture there will be some sanding required after the old finish is removed. We re doing the entire first floor in two phases due to lack of space to put things it s two phases of sand stain and 3 coats of poly. Use denatured alcohol in a disposable aluminum pan to clean off the remaining stripper with the help of steel wool. The job begins after the room is fully cleared.

Choose the best varnish stripper for your needs. Stain is often applied in two coats and can create a strong odor. When your hardwood turns gray it s definitely time to finish and do it soon before you have more damage. That s why we do our utmost to talk you out of staining your wood floors.

Remove the stripper from the wood. Your floors are begging you for your help. You can paint with pure freedom even using a paint sprayer and spillages rarely cause much damage. When you have determined that you do need to strip a piece always remove all the old finish or paint thoroughly.

Here are four big reasons why. Do not use any liquids at all for cleaning any newly refinished hardwood floors until they are fully cured. If you simply have no floor coverings yet and just a subfloor then you will greatly benefit by painting the walls and ceiling before refinishing the floors. You can do this in two steps.